Re: How can the assembly in Solidworks be edited after being imported into Comsol by Livelink?

Dear Frank,

Thank you very much for your reply!

I tried to convert the model to point. Then everything was gone with only a few points left. So do I need to convert them back? Thank you for your attached picture so I could easily find it.

I also tried the split operation. After that, under geometry I got a separate split component. But if I click the splited component, I still don't see where to edit the position of this component.

I attached a simple SolidWorks model and COMSOL model by importing the SolidWorks model. There are two bars. How can I do parametric sweep between these two bars in x, y and z?

I also added another big bar in COMSOL. How can I make the center of this big bar concentric with one of the bars imported from SolidWorks?

I appreciate if you could take a look at my model and give me some advice.

Best regards,
Ruijun